Ürünler

Pepperl Ultrasonik Sensörler
Ultrasonik Sensör Pepperl Fuchs UB200-12GM-E4-V1
5 Aralık 2018
Ultrasonic Sensor Pepperl Fuchs
Ultrasonik Sensör Pepperl Fuchs UC500-L2-E4-V15
5 Aralık 2018
Tümünü Göster

Ultrasonik Sensör Pepperl Fuchs UC500-D1-3K-V7


Sensör
Ultrasonic Sensor
Ultrasonik Sensör
Pepperl Fuchs
Pepperl Fuchs Sensör
Pepperl Fuchs Ultrasonic Sensor
Pepperl Fuchs Ultrasonik Sensör
Pepperl Fuchs UC500-D1-3K-V7
Pepperl UC500-D1-3K-V7

Açıklama

Pepperl Fuchs UC500-D1-3K-V7 Ultrasonik Sensör
Pepperl UC500-D1-3K-V7 Ultrasonic Sensor

Teknik veriler UC500-D1-3K-V7

Ürün Açıklaması
Single head system

 

General specifications
Sensing range 60 … 550 mm
Dead band 0 … 60 mm
Standard target plate 100 mm x 100 mm
Transducer frequency approx. 380 kHz
Response delay > 10 s, relay
< 1 s, LEDs
Indicators/operating means
LED red LED 1: overfill indication
LED 4: underfill indication
LED green/yellow LED 2: overfill warning and normal operation
LED 3: normal operation and underfill warning
DIP switch setting of the switch points/operating modes
Electrical specifications
Operating voltage 10 … 253 V DC
20 … 253 V AC , 47 … 63 Hz
No-load supply current < 30 mA with UB = 30 V DC
< 110 mA at UB = 10 V DC
< 25 mA at UB = 220 V AC
Output
Output type 3 relay outputs, normally open/closed, selectable
Range hysteresis 20 mm
Contact loading 253 V AC/150V DC, 3 A (ohm. load)
Life span electrical: 105 switching cycles with ohmic load
(3 A/253 V AC or 3 A/30 V DC)
minimum contact load: 100 µA/100 mV DC
mechanical: 20 x 106 switching cycles
Temperature influence < 4 %
Fusing ≤ 3 A Slow-blow fuse per output in accordance with IEC 60127-2 Sheet 5 required. Recommendation: after a short circuit, check that the device is functioning correctly.
Compliance with standards and directives
Approvals and certificates
EAC conformity TR CU 004/2011
TR CU 020/2011
CCC approval Certified by China Compulsory Certification (CCC)
Ambient conditions
Ambient temperature -20 … 60 °C (-4 … 140 °F)
Storage temperature -40 … 85 °C (-40 … 185 °F)
Mechanical specifications
Degree of protection IP65
Connection Female connector, V7 (7-pin), 90°
Wire cross section: ≤1.5 mm2
cable diameter ∅7 … 9 mm
Material
Housing cover: PC
housing: PBT
threaded flange: stainless steel
installation connector/cable socket: PETP
Transducer epoxy resin/hollow glass sphere mixture; polyurethane foam
Mass 700 g
Note In case of loss or damage, the cable socket must be replaced by an identical cable socket (type V7-W) from Pepperl+Fuchs!